Frigidaire washing machines fault codes
Every Frigidaire washing machines fault code we have documented, with what it means. Pick yours to see causes, checks and the parts involved.
● 40 codes documented
Frigidaire uses 40 fault codes on its washing machines, shown on the display when the machine stops — among them E11, E13, E14, E21, E23. Each one points to a specific part: on this page you find them all, with what they mean.
How to read the code on the display
On most Frigidaire appliances the code appears on the display when the cycle stops, or is spelled out by a sequence of blinking lights.
Write the code down before switching off: many machines clear it when unplugged, and without the code the fault has to be found from scratch.
Replacement parts
Tools you'll need
Find a specialist
TroubleAtlas Pro
TroubleAtlas Certified
What is the TroubleAtlas Score?
Beyond fault codes and specialists, we rate the reliability of appliance brands and models — a transparent score that owes nothing to the manufacturer. The reference to check before you buy or repair.
See all appliance scores →TA YouTube Channel
All Frigidaire codes
40 codes, in order. Click one to open its page.
| CODE | WHAT IT MEANS |
|---|---|
| E11 | Fill time too long |
| E13 | Water leak in the tub or air leak in the water level pressure sensor air hose |
| E14 | Dispenser drawer not closed |
| E21 | Drains slowly |
| E23 | Drain pump relay failed |
| E31 | Water level pressure sensor isn't communicating with the electronic control board |
| E35 | Water level pressure sensor detects overfill |
| E38 | Clogged air trap |
| E41 | Control detects the door open |
| E43 | Control detects a problem with the door lock circuit |
| E44 | Control board failure |
| E47 | Control detects an open door lock circuit in spin mode |
| E48 | Control detects a problem with the door lock circuit |
| E52 | Bad signal from the drive motor tachometer |
| E53 | Low voltage to the motor control board |
| E54 | Drive motor over speed |
| E55 | Drive motor under speed |
| E56 | High motor current |
| E57 | High current on inverter |
| E58 | High current on motor phase |
| E59 | No tachometer signal for 3 seconds |
| E5A | Motor control board is overheated |
| E5D | Communication failure between the electronic control board and the motor control board |
| E67 | Incorrect voltage supply to the microprocessor on the electronic control board |
| E68 | Heater failure |
| E71 | Heater temperature sensor error |
| E75 | Failed water temperature sensor circuit |
| E95 | Electronic control board communication error |
| EA1 | Incoming power frequency out of limits |
| EA2 | Power supply voltage above 130 VAC |
| EA3 | Power supply voltage lower than 100 VAC |
| EA5 | Main voltage sensing failure |
| EAE | Line safe relay sensing failure |
| EB1 | Incoming power frequency out of limits |
| EB2 | Incoming line voltage is above 130 volts AC |
| EB3 | Incoming line voltage is below 90 volts AC |
| EF1 | Clogged drain pump |
| EF2 | Too much suds |
| EF6 | Control reset |
| EF8 | Stuck button |